DAIKOWT 99

Pure nickel type for welding cast iron.

Austenitic nickel with finely distributed graphite.

Grey iron.

• EN W.Nr.: 1561:2011 Grey cast irons+
• ASTM: A159, A319, A126, A48

Welding of these materials is often performed without preheat; however, for multi-pass deposits or highly restrained joints, preheating up to 150 °C may be necessary. Prior to welding, carefully prepare the surfaces by gouging or grinding, using limited amounts of heat to avoid the propagation of cracks. The area to be welded should be as free as possible from sand, oil, grease, paint, or rust. Preheating can aid in removing impregnated oil from used castings subject to repairs. If proceeding without preheat, it is advisable to minimize the width of the heat-affected zone (HAZ) by using a low heat input and keeping the interpass temperature low. A staggered welding technique can be effective in achieving this result. For welding on thicker or heavily restrained sections, preheating up to 150 °C can be indispensable. A light peening to reduce contraction stresses can be beneficial, but it is important not to compromise the ductility of the weld metal. It is also recommended to butter the joint faces or the sides of the repair cavity before proceeding with filling, regardless of the use of preheat. Upon completion of the welding operations, it is essential to allow for slow cooling of the piece, resorting to insulation if necessary.